Main Menu - Elcometer 456 Operating Instructions Manual

R
Note: If CAL softkey symbol is flashing the gauge
should be recalibrated. This is due to the calibration
adjustment method having been changed or a
probe change - see "Calibration adjustment" on
page 23. Batches cannot be created while the CAL
softkey symbol is flashing.
Figure 11. Reading screen in extended mode
and showing full set of statistical values.
If is shown flashing in the top right corner of
your display, it indicates that your gauge and your
PC have established a Bluetooth
When your gauge and PC are connected by
®
Bluetooth , you can transfer readings and batches
using ElcoMaster software - see "Transferring
readings to a computer" on page 40.
14

4.2 MAIN MENU

Gauge configuration and measurement functions
are controlled using menus (Figure 12). The
structure of the menus is shown on page 18.
Some screens allow the status of a feature to be
changed e.g. on to off or select or deselect, etc. A
tick box
against a menu item indicates the function is
activated or selected.
®
connection.
SEL softkey selects the option displayed and in
some cases toggles the status of a tick box off/on.
Up/Down softkeys h i move the cursor to the menu
item required. The menus scroll up/down and a line
across the screen indicates the start and end of the
menu.
Figure 12. Typical Elcometer 456
indicates this type of feature. A tick
Menu title
Menu contents
Softkey functions
menu
3