Table of Contents
Advertisement
printer shuts down. The battery should then be recharged
fully for 15 hours. When fully charged, the battery pack will
measure 14-14.5 volts, and will power the printer all the way
down to approximately 11 volts. The printer has an auto
shut-off feature which will automatically turn the printer off
after being idle for 5 minutes to conserve battery power.
NOTE:
"WARNING: LOW BATTERY" message is a warning and
may appear with some battery life remaining. Therefore the
printer can continue to be used until it shuts down.
RIBBON CARTRIDGE INSTALLATION
Open the label door of the printer by inserting your finger
into the label exit slot and gently pulling up OR grasp the
label compartment cover and pull up gently. Place the
ribbon cartridge (Part Number LS3-RIB) in the ribbon
compartment with the metal tear bar facing upward and the
manual advance knob on the left (See Figure 2). Turn the
manual advance knob counterclockwise while applying
gentle downward pressure until the knob is positioned.
Continue to turn the manual advance knob while pushing
down on the screws on the metal tearbar until the ribbon
cartridge snaps onto both plastic tabs on the sides of the
rubber drive roller. Once installed, turn the manual advance
knob counterclockwise to make sure the ribbon is loaded
properly. Make sure the ribbon is between the nose of the
print head and the print shield (See Figure 2).
6
Advertisement
Table of Contents
