Table of Contents
Advertisement
Unexpected printing results.
Printhead does not slide freely
or fully.
Ribbon is not advancing
properly.
Code vs. Size error message.
Character does not display on
screen when key is depressed.
Battery pack is fully drained.
Printhead is not moving freely,
causing text to be compressed
together or printed on edge of
label.
Printhead shafts need to be
lubricated.
Battery pack is fully drained.
Ribbon is not loaded correctly.
Ribbon drive pin needs to be
lubricated.
Printer width sensor detects
label width different than that
defined by the label code.
Key is stuck.
24
Charge battery pack, if "LOW
BATTERY" warning message
was previously received.
Make sure ribbon is advancing
freely.
Make sure no labels are stuck
in the printer.
If required, lubricate
printhead shafts (see below
for more information).
Carefully apply a thin film of oil
(Tuffoil Lubit-8, or equivalent)
to the 2 printhead shafts. Tuffoil
Lubit-8 is manufactured by:
Fluoramics, Inc.
18 Industrial Avenue
Mahwah, NJ 07430
Charge battery pack, if "LOW
BATTERY" warning message
was previously received.
Load ribbon properly between
the printhead and print shield.
Carefully apply a small amount
of oil to the drive pin (Tuffoil
Lubit-8, or equivalent).
Verify label code and enter
correct label code, if incorrect.
Close printer door.
Press any key to clear error
message, and ignore.
Make sure no keys are stuck in
the depressed position.
Advertisement
Table of Contents
