Table of Contents
Advertisement
Labels not registering properly,
or stopping at next label.
Not printing.
Print is smudged or too dark.
Print dots missing or light.
Labels are not loaded properly.
Sensor is dirty.
Printer is not ready to operate.
Ribbon is not loaded correctly.
Drive roller or print shield is
dirty.
Ribbon problem.
Drive roller is not seated
properly.
Printhead has broken pin or
blown solenoid (visible if a
portion of the line of text is
missing).
23
Make sure labels are properly
loaded on mandrel, and side
guides are positioned correctly.
Labels should be located as far
to right as possible.
Make sure printhead is
located in the center of the
printer.
Carefully clean registration
sensor located to the right side
of drive roller by blowing on
the opening of the sensor.
Make sure printer:
1. Is turned on.
2. Has ribbon cartridge
properly loaded.
Load ribbon properly between
the printhead and print shield.
Remove ribbon cartridge, and
carefully clean drive roller,
print shield, and print
mechanism assembly with
isopropyl alcohol and cotton
swab.
Make sure ribbon is properly
installed between the
printhead and print shield, and
ribbon manual advance knob is
spinning during printing.
Ribbon is worn. Replace ribbon.
Ribbon not advancing.
Remove cartridge from
printer, and make sure ribbon
can be advanced by turning
knob on ribbon cartridge
counter-clockwise. Install
ribbon properly.
Make sure drive roller is not
skewed and is firmly
supporting the label stock.
Contact Panduit Technical Ser-
vice at (888)506-5400
extension 7470.
Advertisement
Table of Contents
