Table of Contents
Advertisement
SECTION 1: Using the SETUP Menu
Step 1: Turning the Printer On:
Locate the POWER Key, represented by the
in the upper left hand corner of the keypad. Press and hold
the POWER Key until the print head cycles. The LS3E will
display the last label code in use.
Step 2: Loading/Removing the Labels:
1. Load labels on mandrel (label roll holder), as shown on
the decal inside the printer door.
2. Look inside the label door area and locate the label width
guides found behind the print mechanism. Push the left
guide into the appropriate slot in the aluminum base to
match your label width.
position.
3. Place leading edge of label liner under the rubber drive
roller until contact is made, label side down (See Figure
3 for label orientation when loading ). Insure the labels
are loaded all the way to the right side.
4. Press and release the FEED Key to load the labels into
printing position.
5. Place mandrel behind label width guides and close the
cover door.
MEDIA WIDTH GUIDE.
FOR ADJUSTMENT OF SELECTED LABELS,
LIFT AND SLIDE (LEFT OR RIGHT) TO
PROPER SLOT
WHEN LOADING ROLL OF LABELS INTO
THE PRINTER, THE LABEL SIDE SHOULD
FACE DOWNWARD
Be sure the guides lock into
FIGURE 3
8
symbol, found
RUBBER
DRIVE ROLLER
Advertisement
Table of Contents
