Location Requirements - Konica Minolta DRYPRO SIGMA Installation Manual

Pre-Installation Manual
Use the checklist to prepare to install the laser imager. Review and complete
these requirements. After you receive the laser imager, review the Safety
Manual before starting the installation. If you have questions, contact your
Sales Representative or qualified Service Provider. When finished, return
the signed Pre-Installation Manual to your Service Provider.
Power Requirements
A power cord is provided with this equipment. All countries must use an Agency-approved
Ready?
power cord with a plug type suitable for the country of use. Connect the equipment to a power
source that is suitable for the voltage and current ratings at your site:
• Input voltage = 90 - 132 V (ac), 50/60 Hz ± 3 Hz
• Input voltage = 180 - 264 V (ac), 50/60 Hz ± 3 Hz
The single-phase power source, with grounding, must be provided within 2.5 m (8.0 ft) of the
laser imager. The wire must be insulation-rated for input voltage = 600 V (ac). A dedicated line
is recommended.
Network Requirements
The laser imager receives digital images from medical imaging devices (modalities) over a
Ready?
10/100Base-T or 1000Base-T Ethernet Network.
During the installation, you will enter the network information for the laser imager to let it
communicate across the network.
Gather and record the information in the following table prior to the installation. See your site's
network administrator for help to gather the information. Have this page available when you
start the installation.
Required Information for the Laser Imager:
Host (Computer) Name
IP Address - Use the format: xxx.xxx.xxx.xxx
Subnet Mask - Use the format: xxx.xxx.xxx.xxx
Default Gateway - Use the format: xxx.xxx.xxx.xxx
DICOM Port Number - The default port number, 5040,
is correct for most installations. If necessary, you can
change it for your site. You will enter the port number in
two places: at the modality and at the laser imager.

Location Requirements

Allow 15 cm (6 in.) clearance around the top, sides, and back of the laser imager.
Ready?
The surface must be a level (within 1°) table top or counter capable of supporting the weight of
the laser imager.
Height
Width
Depth
Weight
Pub No. 9G7563_en
Unpacked Packed
47 cm (19 in.) 74 cm (29 in.)
61 cm (24 in.) 79 cm (31 in.)
66 cm (26 in.) 85 cm (34 in.)
54 kg (120 lbs) 73 kg (160 lbs)
© KONICA MINOLTA, INC., 2013
Complete the table:
2013-04-01