Sony PCM-7040 Operation Manual page 76

Operation example: When using the BVE-9100
1
Press the JOG key while holding down the CTRL
key. Then, press the JOG key again.
The unit stores the played-back sound, around the
point where the JOG key is pressed, to sound
memory. The status display shows "MJOG".
or
Press the JOG key while holding down the CTRL
key. Then locate the edit point or desired point by
using the OUT or SCR-PAD and GO TO keys.
The unit automatically stores the played-back
sound as the start point of the locate point.
The status display shows "MRDY".
2
Press the JOG key, then turn the search dial.
The unit plays back the sound stored in sound
memory at a speed from still to normal speed. The
time code of the sound in the sound memory is
displayed under "POSITION" on the display.
3
Press the PLAY key while holding down the
CTRL key.
The unit plays back the sound from the time code
displayed under "POSITION" to the end of the
sound in memory at normal speed. The status
display shows "MPLY".
4
Set the edit point by pressing the MARK IN or
MARK OUT key.
To release memory jog mode
Press any key other than the JOG key. Memory jog
mode is released.
When using a video editor that can not control
memory jog
Settings of this unit
1
Set the setup menu "JoG ctL" item to "on-1" or
"on-2".
2
Set the setup menu "StArt" item to "Edit-E" or
"Edit-c".
3
Set the REMOTE (9P)/LOCAL selector to
LOCAL mode and set the unit to memory start
mode by pressing the MEMORY START key. Or,
set the setup menu "iS dFLt" item to "on", then
turn on the power. And then, set the selector to
REMOTE mode.
Operation example: When using the BVE-900
1
When "JoG ctL" is set to "on-1", use the OUT or
SCR-PAD and GO TO keys to locate an edit point
or desired point.
The unit automatically stores the played-back
sound as the start point of the locate point.
When "JoG ctL" is set to "on-2", press the JOG
key during playback.
2
Press the JOG key, SHTL or VAR key, then turn
the search dial. The unit plays back the sound
stored in the sound memory at a speed from still to
normal speed. The time code of the sound in the
sound memory is displayed under "POSITION" in
the display.
3
Set the edit point by pressing the MARK IN or
MARK OUT key.
To release memory jog mode
Press any key other than the JOG, SHTL and VAR
keys. Memory jog mode is released.
Chapter 8 Application Systems
8-3