Sony PCM-7040 Operation Manual page 43

4-2 Recording Procedure
Renumbering program numbers
You can renumber Program numbers.
Set the initial value and perform renumbering in the
display key menu.
1
Press the DISPLAY key and set the display to
"rEno—".
* * * *
2
Press the MENU key to select the point you want
to start renumbering.
b: from the tape top
c: from the current point
3
To set the initial value, turn the search dial while
holding down the DATA key.
You can set any value between 01 and 799 as the
initial value.
You don't need to press the SET key.
To increase the initial value: Turn the search
dial clockwise.
To decrease the initial value: Turn the search
dial counterclockwise.
To reset the initial value to "01": Press the
RESET key while holding down the DATA
key.
4
Press the INSERT SUB key.
The recording mode changes to insert subcode
mode.
4-12
Chapter 4 Recording
2 1
4 5 3
Initial value (01 to 799) of program
number
The start point of renumbering
5
Press the SET key while holding down the DATA
key.
The unit searches for the Start IDs from the point
you selected. It then writes the Program numbers
sequentially from the initial value. When the tape
reaches the end, the unit rewinds the tape. If, for
example, you set the initial value to "100", the unit
writes the Program numbers counting 100, 101,
102 and so on.
The unit displays the following data.
* * * * * *
When the unit finishes renumbering or when you
intempt renumbering by pressing the STOP key, the
initial value returns to "01".
Note
If the recorded Program number exceeds 799, the unit
records "0AA" (invalidity) onto the tape. Locating to
Program number "0AA" is impossible.
Initially set value
Current program number