Sony PCM-7040 Operation Manual page 24

Example 2: When the recorder is a controlling device
Switch Settings
SYNC signal selector (front panel): EXT
INPUT MONITOR key (front panel):
Turned off
Setup menu setting
din Sync (DIN SYNC): on or oFF
Switch Settings
SYNC signal selector (front panel): INT
AUDIO INPUT selector
(front panel): DIGITAL
INPUT MONITOR key
(front panel): Turned off
Setup menu setting
rEc tc (REC TIME CODE): INPUT
(When you don't want to copy the time
code.)
Notes
• To make a digital copy with the time code and the
audio signals in line with each other, set the "tc dLY"
(time code delay) of a dial menu to "d out" (digital
output).
See section 7-3 "Dial Menu Operations" (page 7-5).
• In digital copying between two PCM-7040s, the unit
doesn't copy the subcode signals such as Start ID or
ABS TIME even if you follow the above setting. To
copy subcode ID signals, follow one of the
procedures below:
DIGITAL INPUT
DIGITAL OUTPUT
Digital audio signal
DIGITAL OUTPUT
DIGITAL INPUT
3)
The number in ( ) refers to the pin number of the REMOTE
(37P) connector.
Player
1)
Recorder
1), 2) Signal either 1) or 2) is used as external sync
signal.
3) When you record the time code of the player, set
this setting.
— First copy the audio signal and time code signal.
Then write the subcode IDs in the INSERT mode.
— Make connections in the REMOTE (37P)
connector as shown below, then you can copy
Start ID, Skip ID, and End ID, as well as the audio
signals and the time code signals simultaneously.
Note that in this digital copy, the copied ID
signals are 1 to 3 frames behind the audio signals
and the time code signals.
OUTPUT side
START ID STATUS OUT (11) ˜ START ID WRITE COMMAND IN (30)
SKIP ID STATUS OUT (12) ˜ SKIP ID WRITE COMMAND IN (31)
END ID STATUS OUT (13) ˜ END ID WRITE COMMAND IN (32)
WORD SYNC INPUT
Time code 3)
2)
Word sync signal
WORD SYNC OUTPUT
INPUT side
3-5
Chapter 3 Preparations