Sony PCM-7040 Operation Manual page 10

!¥
S
POWER
ON
OFF
REMOTE (9P)
LOCAL
HEADPHONES
MIN MAX
!• STANDBY key
When pressed while its light is off, lights and causes
the unit to go into the STANDBY ON state (the head
drum rotates while the tape stops). The unit can start
playback more quickly in the STANDBY ON state
than in the STANDBY OFF state. If you leave the
unit in the STANDBY ON state, the state will
automatically go off after about 3 minutes, causing this
key light to go out and the drum to stop rotating. If
you want to enter the STANDBY ON state again,
press the key again.
!ª Warning indicators
ALARM indicator (red)
When an error is detected, this indicator lights and the
corresponding error number appears on the display. If
the error is a serious one, the tape will stop running.
See "When the ALARM Indicator Comes On" (page 9-1)
for more information.
MUTE indicator (red)
Lights if playback is muted due to poor playback
conditions.
PB (playback) CONDITION indicator (yellow)
Lights if the error rate goes high due to poor playback
conditions. If this indicator lights, inspect the tape as
well as the tape transport section of the unit.
Using a dial menu, you can change the conditions
under which this indicator lights.
See section 7-3 "Dial Menu Operations" (page 7-5) for
menu operation.
!» @...
ALARM MUTE PB CONDITION SERVO REC INH
START ID
EJECT STANDBY
PREVIOUS NEXT
MEMORY
START
6 e = +
REW FF PLAY STOP REC
LOCATE
0 ) ( p r
@ @⁄@ƒ@¥
@` @"
SYNC
EXT
INT
VIDEO
C
DISPLAY
C
MENU
START ID
SYNC
WREITE ERASE MARK
REC
DATA
INPUT
MONITOR
B
SET
B
INSERT
VARI CHASE ASSEMBLE
AUDIO SUB CUE
SPEED
RECET
#...#` #"
@»
SERVO lock indicator (green)
Lights when the servo system is locked or when chase
synchronization is achieved.
REC INH (record inhibit) indicator (yellow)
Lights when a cassette with its hole open (record
inhibit setting) is loaded in the cassette compartment.
@º MEMORY START key and indicator
Used to store the initial portion of sound to be played
back on the built-in sound memory, so that you can
start playing back instantaneously (memory start).
See section 6-2-1 "Outputting Playback Signals
Immediately after Pressing the PLAY key—Memory Start
Function" (page 6-4) for the procedure for making a
memory start.
@¡ SYNC REC key and indicator
When pressed while its light is off, lights and causes
the recording mode to be set to "Sync recording".
See section 4-1-3 "Selecting the Recording Mode" (page 4-
1) for the procedure.
Chapter 2 Location and Function of Parts and Controls
@£ @¢
AUDIO INPUT CH-1
ANALOG
DIGITAL
MIN MAX
SAMPLING
CH-2
44.1 kHz
D 48 kHz D
MIN MAX
REW FWD
(Continued)
2-3