Selecting The Sync Signal; Selecting The Remote/Local Setting - Sony PCM-7040 Operation Manual

3-3 Supplying the Power and Initial Settings

3-3-5 Selecting the Sync Signal

One of the following sync signals is required for
synchronized operation. Select the appropriate signal
with the SYNC signal selector.
EXT: This unit synchronizes with either the D-I sync
signal (D-I) or word sync signal (WORD)
according to the setting of "din Sync"
(DIN SYNC) in the setup menu.
INT: This unit synchronizes with the internal clock
signal. Set the selector to this position when you
use this unit as the controlling device, or use only
this unit without connecting another unit.
VIDEO:This unit synchronizes with the video sync
signal coming from the video equipment which is
connected to the REF VIDEO INPUT connector
or rectangular signal.
3-10
Chapter 3 Preparations
Select the REMOTE (9P)/LOCAL setting according to
the system configuration.
SYNC
EXT
INT
VIDEO
3-3-6 Selecting the REMOTE/
LOCAL Setting
REMOTE (9P): You can control this unit only from
the controller connected to the REMOTE (9P)
connector on the connector panel. In this case, it
is not possible to control from the front panel,
REMOTE (8P) connector and REMOTE (37P)
connector on the connector panel except for the
keys and the switches listed below.
• STOP key
• EJECT key
• DISPLAY key
• Dial menu keys (MENU, DATA, SET, and
RESET keys)
• SYNC signal selector
• AUDIO INPUT selector
• SAMPLING FREQ selector
You can also control this unit from the front panel,
REMOTE (8P) connector and REMOTE (37P)
connector (except the RS-232C connector) by
setting the setup menu of "LocAL" to "EnAbLE".
LOCAL: You can control this unit from the front
panel as well as controllers connected to the
REMOTE (8p) connector, REMOTE (37P)
connector, and RS-232C connector on the
connector panel.
REMOTE (9P)
LOCAL