Sony PCM-7040 Operation Manual page 15

2-2 Display
4 Lock range indicator
Indicates "WIDE" when the wide range is selected for
external synchronization. (You do this by setting the
setup menu "SYNC NARROW" to "OFF".) The
factory setting of "SYNC NARROW" is "ON".
See section 7-3 "Dial Menu Operations" (page 7-5).
5 DISPLAY key menu display area
Every time you press the DISPLAY key on the front
panel, the DISPLAY key menu in the input/set data
display area changes. The menus displayed and their
functions are as follows:
See section 7-2 "DISPLAY Key Menu Operations" (page 7-
4) for more detailed information.
LOCATE POINT: This menu shows a locate point
time code data.
LOCATE POINT (Program number): This menu
shows the current Program number and the locate
point Program number.
Pno: This menu shows a program number to be
recorded with the start ID in assemble recording
mode.
ELAPSE: This menu shows the tape running time.
U-BIT: This menu shows the user bit data read from
the tape.
EXT TIME CODE: This menu shows the external
time code being input.
EXT U-BIT: This menu shows the external user bit
data being input.
GEN TIME CODE: This menu shows the time code
generated by the built-in time code generator.
GEN U-BIT: This menu shows the user bit data
generated by the built-in time code generator.
GEN SET TIME: This menu shows the initial value
of the time code to be generated by the built-in
time code generator.
GEN SET U-BIT: This menu shows the user bit data
to be generated by the built-in time code
generator.
VARI SPEED: This menu shows the tape speed for
variable-speed playback (VARI-SPEED mode).
CHASE OFFSET: This menu shows the chase offset
time.
rEno: This menu shows the initial value of the
Program number when the unit is renumbering the
Program numbers.
SHtL/JoG: This menu shows the cue speed when the
unit is in cue mode.
2-8
Chapter 2 Location and Function of Parts and Controls
6 Generator mode indicator
Displays "FREE FUN" when the generator mode is set
to FREE RUN. (You do this by setting the setup
menu "FREE RUN" to "ON".) The factory setting of
"FREE RUN" is "OFF" (REC RUN).
See section 7-3 "Dial Menu Operations" (page 7-5).
7 Emphasis indicator
Displays "EMPH" while de-emphasis circuitry is
being activated.
8 Time code mode indicator
When the SMPTE time code is used, this indicator
displays "NDF" (for non-drop frame mode) or "DF"
(for drop frame mode) depending on the mode of time
code used. You can change the setting using a setup
menu.
See section 7-3 "Dial Menu Operations" (page 7-5).