NetModule NB3700 User Manual page 57

Parameter
Hardware flow control
Protocol on TCP/IP
Port
Timeout
Parameter
Protocol on IP port
Port
Timeout
Allow remote control
Show banner
Stop bits
Allow clients from
Please note that the device server does not provide authentication or encryption and
clients will be able connect from everywhere. Please consider to restrict access to a
limited network/host or block packets by using the firewall.
NB3700 User Manual 3.8
Serial Settings
You may enable RTS/CTS hardware flow control, so that
the RTS and CTS lines are used to control the flow of data
You may choose the IP protocols Telnet or TCP raw for the
device server
The TCP port for the device server
The timeout until a client is declared as disconnected
Server Settings
Selects the desired IP protocol (TCP or Telnet)
Specifies the TCP port on which the server will be available
The time in seconds before the port will be disconnected if
there is no activity on it. A zero value disables this function.
Allow remote control (ala RFC 2217) of the serial port
Show a banner when clients connect
Specifies the number of stop bits used to indicate the end
of a frame
Specifies which clients are allowed to connect to the server
57