NetModule NB3700 User Manual page 45

link is being dialed.
Generally, the connection settings are derived automatically as soon as the modem has
registered and the network provider has been found in our database. Otherwise, it will
be required to configure the following settings manually:
Parameter
Phone number
Access point name
Authentication
Username
Password
Furtheron, you may configure the following advanced settings:
Parameter
Required signal strength Sets a minimum required signal strength before the connec-
Home network only
Negotiate DNS
Call to ISDN
Header compression
Data compression
Client address
MTU
NB3700 User Manual 3.8
WWAN Connection Parameters
The phone number to be dialed, for 3G+ connections this
commonly refers to be *99***1#. For circuit-switched 2G
connections you can enter the fixed phone number to be
dialed in international format (e.g. +41xx).
The access point name (APN) being used
The authentication scheme being used, if required this can
be PAP or/and CHAP
The user-name used for authentication
The password used for authentication
WAN Advanced Parameters
tion is dialed
Determines whether the connection should only be dialed
when registered to a home network
Specifies whether the DNS negotiation should be performed
and the retrieved name-servers should be applied to the sys-
tem
Has to be enabled in case of 2G connections talking to an
ISDN modem
Enables or disables 3GPP header compression which may
improve TCP/IP performance over slow serial links. Has to
be supported by your provider.
Enables or disables 3GPP data compression which shrinks
the size of packets to improve throughput. Has to be sup-
ported by your provider.
Specifies a fixed client IP address if assigned by the provider
The Maximum Transmission Unit for this interface
45