Panasonic KX-TD500 Features Manual page 141

• Group Login / Logout
When a single extension belongs to multiple different Incoming Groups at a
time, Group Login / Logout setting works on the Incoming Group basis.
• UCD Supervisory Features
Login Monitor
<For Extension Group members>
Login / Logout status of the UCD Group members can be monitored through
Busy Lamp Field of the corresponding DSS button.
Login Monitor is enabled or disabled by System Programming <Section 3.3
Extension Group, "LOGIN Monitor" in the Programming Guide>.
<For Incoming Group members>
Login / Logout status of the UCD Group members can be monitored by the
extension specified as the Supervisor Extension through Busy Lamp Field of
the corresponding DSS button.
• UCD Monitor Mode
The extension specified as the Supervisor Extension can monitor the number of
calls put in the waiting queue by dialing the feature number for "UCD Monitor
Mode."
You can also use the Features menu of a large display DPT.
The extension that can perform this feature is determined by System
Programming <Section 3.3 Extension Group / 3.5 Incoming Group, "Supervisor
Extension" in the Programming Guide>.
• What if a call ringing on a member extension is not answered?
If not answered within a specified period of time (Call Forwarding — No
Answer Time), the call is transferred to the next idle member extension, or the
call continues to ring on the current destination extension.
This is determined by System Programming <Section 3.3 Extension Group / 3.5
Incoming Group, "FWD-No Answer" in the Programming Guide>.
• Auto Logout
A member extension may be logged-out automatically, if it does not answer the
call for pre-determined times (1-10) consecutively. This is determined by
System Programming <Section 3.3 Extension Group / 3.5 Incoming Group,
"Auto Logout Mode" in the Programming Guide>.
PT: To use this feature correctly, program Login / Logout (Group Login /
Logout) button. After the system activates Auto Logout, press Login / Logout
(Group Login / Logout) button in the off-hook status to go back to the Login
mode.
Any telephone: After the system activates Auto Logout, enter the feature
number for Login (Group Login) in the off-hook status to go back to the Login
mode.
Features Guide
To start UCD monitor: dial feature number + UCD Group FDN
To end UCD monitor: dial feature number + " "
General Features
141