Rj-11 Connector Cable - HP ProBook 6360b Maintenance And Service Manual

e.
f.
g.
h.
i.
Remove the ExpressCard assembly:
1. Position the top cover upside-down, with the front toward you.
2. Remove the three Phillips PM2.5×5.0 screws (1) that secure the assembly to the top cover.
3. Lift the tab of the assembly (2) until it disengages from the opening in the top cover.
4. Remove the ExpressCard board and cable (3) from the top cover.
Reverse this procedure to install the ExpressCard assembly.

RJ-11 connector cable

NOTE:
Before removing the RJ-11 connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
Downloaded from LpManual.com Manuals
Fan (see Fan on page 76)
Heat sink (see Heat sink on page
Base enclosure cover (see
Display assembly (see Display assembly on page
System board (see System board on page
The RJ-11 connector cable is included in the Cable Kit, spare part number 639473-001.
78)
Base enclosure cover on page
89)
96)
82)
Component replacement procedures
105