Rj-11 Connector Cable - HP EliteBook 8530p Maintenance And Service Manual

3. Position the base enclosure with the rear panel toward you.
4. Remove the one black Phillips PM2.0×3.0 screw (1) that secures the system board frame to the
base enclosure.
5. Lift the system board (2) and frame and slide them to the right (3) to remove them from the base
enclosure.
NOTE:
route cleanly through the openings in the system board frame.
Reverse the preceding procedure to install the system board.

RJ-11 connector cable

NOTE: The RJ-11 connector cable is included in the Cables Kit, spare part number 452198-001.
Before removing the RJ-11 connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Switch cover (see
e. Display assembly (see
When removing the system board and frame, be sure that the USB/audio board cables
Battery on page
Hard drive on page
Optical drive on page
Keyboard on page
Switch cover on page
Display assembly on page
43).
49)
45)
59)
64)
67)
Component replacement procedures 89