Reset; Exit - Wirepath Surveillance WPS-550-DOM-A-WH Installation Manual

WPS-550-DOM-A Installation Manual
ID POS
Select the position for the CAMERA ID on the display screen by using
the left and right arrows "", "" to move the ID.
LANGUAGE Setting
There are 2 language options: English and Chinese.
VERSION
Displays the factory firmware version.

RESET

If adjustment to the camera's settings results
in poor picture quality, it is recommended
to restore the camera to factory default
settings. All configurations with the exception
of the COMM SETTINGS can be reset back
to factory default settings by selecting
FACTORY RESET and pressing the MENU
button. This option does not have an
"UNDO" feature, so ensure default settings
are desired before selecting this function.

EXIT

1. Select EXIT to exit the OSD menu.
2. Attach the Dome to the Camera
Note: The camera is equipped with Silica packs that absorb moisture in the
camera to prevent condensation on the lens. DO NOT remove the Silica pack
unless it is being replaced.
A. Replace the dome cover to the
dome base, and make sure the
screws on the dome cover are
tightened securely. Doing so seals
the dome from the elements,
and creates a tight fit around the
rubber lens gasket to prevent the
IR LEDs from reflecting into the lens.
24
RESET
FACTORY RESET
RETURN RET
Lens Rubber Gasket