Replacing The Internal Clock Battery - Christie LWU701i Operating Manual

Maintenance

Replacing the internal clock battery

Replace a battery according to the following procedure.
1.
Turn the projector off, and unplug the power cord. Allow the
projector to cool sufficiently.
2.
After making sure that the projector has cooled adequately,
slowly turn over the projector, so that the bottom is facing
up.
3.
Turn the battery cover fully in the direction indicated "OPEN"
using a coin, and pick the cover up to remove it.
4.
Pry up the battery using a flathead screwdriver to take it
out. While prying it up, put a finger lightly on the
battery as it may pop out of the holder.
5.
Replace the battery with a new HITACHI MAXELL,
Part No.CR2032 or CR2032H.
Slide the battery in under the plastic claw, and push it
into the holder until it clicks.
6.
Replace the battery cover in place, then turn it in the
direction indicated "CLOSE" using a coin.
WARNING ►Always handle the batteries with care and use them only as
directed. Battery may explode if mistreated. Do not recharge, disassemble or
dispose of in fire.
Improper use may result in cracking or leakage, which could result in fire, injury
and/or pollution of the surrounding environment.
・ Be sure to use only the batteries specified.
・ Make sure the plus and minus terminals are correctly aligned when loading a battery.
・ Keep a battery away from children and pets. If swallowed consult a physician
immediately for emergency treatment.
・ Do not short circuit or solder a battery.
・ Do not allow a battery in a fire or water. Keep batteries in a dark, cool and dry place.
・ If you observe battery leakage, wipe out the leakage and then replace a battery. If the
leakage adheres to your body or clothes, rinse well with water immediately.
・ Obey the local laws on disposing a battery.
LWU701i/LW751i/LX801i/LWU601i/LW651i
User's Manual - Operating Guide
112
Battery Cover
90°
OPEN
CLOSE
90°
020-000786-02
LIT MAN USR D2