Security Menu - Christie LWU701i Operating Manual

SECURITY menu

This projector is equipped with security functions.
From the SECURITY menu, items shown in the table
below can be performed.
To use SECURITY menu: User registration is required
before using the security functions.
Enter to the SECURITY menu
1. Press the ► button. The ENTER PASSWORD box is displayed.
2. Use the ▲/▼/◄/► buttons to enter the registered password. The
factory default password is as follows.
LWU601i/LWU701i : 6514 LW651i/LW751i : 4814 LX801i : 6414
This password can be changed
right side of the ENTER PASSWORD box and press the ► button to
display the SECURITY menu.
• It is strongly recommended the factory default password to be
changed as soon as possible.
• If an incorrect password is input, the ENTER PASSWORD box
is displayed again. If incorrect password is input three times, the
projector turns off. Afterwards the projector then turns off every time
an incorrect password is input.
3. Items shown in the table below can be performed.
If you have forgotten your password
(1) While the ENTER PASSWORD box is displayed, press and hold
the RESET button on the remote control for approximately three
seconds or press and hold the INPUT button for three seconds while
pressing the ► button on the projector.
(2) The 10 digit Inquiring Code is displayed. Contact your dealer with
the 10 digit Inquiring Code. Your password is sent after your user
registration information is confirmed.
• If there is no key input for approximately 55 seconds while the Inquiring Code is displayed, the menu
closes. If necessary, repeat the process from (1).
Item
SECURITY
PASSWORD
CHANGE
(continued on next page)
LWU701i/LW751i/LX801i/LWU601i/LW651i
User's Manual - Operating Guide
(below)
. Move the cursor to the
(1) Use the ▲/▼ buttons on the SECURITY menu
to select SECURITY PASSWORD CHANGE
and press the ► button to display the ENTER
NEW PASSWORD box.
(2) Use the ▲/▼/◄/► buttons to enter the new password.
(3) Move the cursor to the right side of the ENTER
NEW PASSWORD box and press the ► button
to display the NEW PASSWORD AGAIN box,
enter the same password again.
(4) Move the cursor to the right side of the NEW
PASSWORD AGAIN box and press the ►
button and the NOTE NEW PASSWORD box is
displayed for approximately 30 seconds. Make
note of the password during this time.
Pressing the ENTER button on the remote control or ► button on the
projector closes the NOTE NEW PASSWORD box.
• Do not forget your password.
Description
101
SECURITY menu
020-000786-02
LIT MAN USR D2