Stihl ASA 85 Instruction Manual page 33

Other malfunctions:
Malfunction:
LED on charger flashes red
Runtime is too short
Cutting performance of pruning shears sud-
denly deteriorates
1)
STIHL recommends an authorized STIHL servicing dealer.
Temperature Monitoring
The electronic control automatically
reduces cutting performance if the
cordless pruning shears or the control
unit become too hot. The following
message appears on the display.
° C ! ° C ! ° C !
ASA 85
Cause
No electrical contact between charger
and battery
Malfunction in battery
(4 LEDs on battery flash red for
about 5 seconds)
Malfunction in charger
Battery not fully charged
Useful life of battery has been reached
or exceeded
Insufficient grease between cutting and
anvil blades
Cutting blade dull
Too little play between cutting and anvil
blades
Different ambient and cutting conditions see "Working Techniques"
Pruning shears overheated.
See "Temperature Monitoring"
Remedy
Remove the battery and refit it
Remove the battery from the charger
and fit it in the battery bag in the back-
pack. Switch on the power tool at the
controller – if the LEDs continue to flash,
the battery has a malfunction and must
be replaced.
Have charger checked by your servicing
1)
dealer
Charging the Battery
Have battery checked by servicing
1)
dealer
Use grease gun to pump grease into the
reservoir between the cutting and anvil
blades
Sharpening the cutting blade
Loosen adjusting nut and readjust play
between cutting and anvil blades
Reduce working speed or thickness of
cut Wait for the power tool to cool down
English
31