Operating Instructions - Stihl ASA 85 Instruction Manual

English

Operating Instructions

Controller
The controller is used to switch on the
cordless pruning shears, set the
following functions and view information
(battery's state of charge, number of
cuts, ...).
1
3
3
2
1 Display
2 On/off switch
3 Control lever with the following
positions
14
PGUP
PUSH
PGND
The following commands are used in
menu navigation.
PGUP: Back to previous menu
item
PUSH: Confirm selection
PGND: Go to next menu item
Functions after Switch-On
Status
XX #
The display shows the number of cuts
that can be performed before the next
recommended service is due.
After a few seconds the display
automatically changes to the battery's
state of charge.
If the number of cuts before the next
recommended service is 0 or less, the
changeover to the battery's state of
charge must be performed manually
with the control lever, i.e. "PUSH".
Menu Navigation
Battery's state of charge
Batt: I I I I I I I I I I
Each bar represents 10% of the
battery's capacity
Menu commands:
PGND
Cut statistics
# 123456
Left: Number of cuts since
counter was last set to "0"
– "RESET"
Right: Running time in hours
and minutes since coun-
ter was last set to "0" –
"RESET"
Menu commands:
PUSH 2 sec.
PGND
xxxxxxx
Type of cut
42% S
The electronic control system classifies
each cut on the basis of its energy
consumption. The classifications (S, M,
L) show how many small, medium and
large cuts have been performed since
the counter was last set to "0" –
"RESET".
S Number of small cuts in %
M Number of medium cuts in %
L Number of large cuts in %
Menu commands:
PUSH 2 sec.
PGND
PGUP
↓ ↑
23h 45m
RESET
→
PGUP
↓ ↑
37% M 21% L
RESET
→
PGUP
↓ ↑
ASA 85