Gas Engine Hydraulic Pump Belt; Parking Brake Cable - Cushman Turf Truckster Parts & Maintenance Manual

5.8

GAS ENGINE HYDRAULIC PUMP BELT _______________________________________

Inspect and adjust new belt after first 24-48 hours of
operation. Adjust every 200 hours thereafter.
Adjust hydraulic pump belt so belt deflects 1/4" to 1/2" (6
-12 mm) with a 20 lb. push at midpoint between pulleys.
If tension is incorrect, loosen pump mounting bolts (G)
and carefully pry away from the engine until proper belt
tension is achieved.
5.9

PARKING BRAKE CABLE ___________________________________________________

1. Remove the engine cover. Put chocks in front of and
behind at least two wheels at opposite corners of
vehicle.
2. Engage parking brake. If handle is at an angle
greater than 45° to the panel, adjustment is
required.
3. Disengage parking brake.
4. Tighten adjustment nut (E) a couple of turns.
5. Engage parking brake. Repeat steps 3 and 4 until
handle is at approximately a 45° angle when parking
brake is engaged.
ADJUSTMENTS
E
5
G
Figure 5I
Figure 5J
GB-13