LEGACY RailSounds sound system operations
Installing the battery
A
lthough the LEGACY RailSounds sound system is powered through the track, we
recommend that you install a nine-volt alkaline battery in the tender to prevent the
sound system from shutting down during track power interruptions (for example, at a switch
or a dirty section of track). Follow these steps and refer to Figure 4 page 11 as you install
the battery.
If the RailSounds sound system turns off during interruptions in track power, you
Note!
may need to replace the battery.
1. Lift the upper deck off the tender body. Refer to Figure 4 page 11.
Be careful to avoid pulling on any wires.
2. Remove the protective cover from the battery harness.
3. Snap the battery harness onto the nine-volt alkaline battery's terminals.
4. Slide the battery into the battery holder.
5. Replace the upper deck on the body. Be careful to avoid pinching wires.
71-1155-250 ATSF 3000.indd 10
10
4/28/10 8:35 AM