Table of Contents
Advertisement
TrainMaster Command Control operations
Assigning your locomotive a new ID#
A
s your roster of TrainMaster Command Control-equipped locomotives grows, you will want
to give each unit a unique ID#. The locomotive will respond to commands associated with
its ID# while all other units will disregard these commands.
1. Slide the program run switch on your locomotive to the PROG position. See Figure 2
on page 8.
2. Place the locomotive and tender on the track.
3. Connect the Command Base and plug it in.
4. Power up the track.
5. Press ENG.
6. Enter the unique ID#. Choose any number from 1 to 99 that has not been assigned to
another locomotive (ENG). We recommend using a part of your locomotive's cab number.
7. Press SET. The locomotive's whistle will sound, or the headlights will flash if the
RailSounds sound system is off.
8. Slide the program run switch back to the RUN position.
The locomotive's ID# has been set. Be sure to record the new ID# for your reference.
Reprogramming your locomotive to restore features
I
f your locomotive is unresponsive to your commands in the TrainMaster Command Control
environment, we recommend that you follow this procedure to reset your locomotive. All
factory default settings will be restored when you reprogram the locomotive.
1. Slide the program run switch to the PROG position.
2. Plug in and connect your Command Base.
3. Place your locomotive and tender on the track, then power up the track.
4. Press ENG and enter the locomotive's ID#.
5. Press SET.
6. Press ENG and enter the locomotive's ID# again.
7. Press AUX1.
8. Enter 1 for this particular locomotive.
9. Turn off track power and wait ten seconds.
10. Slide the program run switch back to the RUN position.
At this point, your locomotive has been reset. Restore power to the track and operate the
locomotive as usual. Be sure to use the ID# entered in Step 4.
71-1155-250 ATSF 3000.indd 27
27
4/28/10 8:35 AM
Advertisement
Table of Contents
