Lionel VISION ATSF 3000 2-10-10-2 Owner's Manual page 35

Locomotive and tender

Table of Contents

Maintaining and servicing your locomotive

Adding fluid to your locomotive's smoke generators

our locomotive is equipped with two smoke generators that produce a safe, clean, white

smoke during operation.Your VISION Line ATSF 3000 s has one smoke generator for the

main smoke stack and one for the auxiliary smoke unit. The auxiliary unit is for the

new TruRail features of whistle and blowdown steam. It is located under a removable

dome right in front of the bell. The dome is held on with two magnets. Lift up the

dome and place the included funnel into the hole. For the first time we recommend

using 20 drops of smoke fluid. From then on 10 to 20 drops will be sufficient. For the

main smoke stack at the front of the engine 20 drops will be enough, and 10 to 20

thereafter. DO NOT EXCEED 20 DROPS as this can cause your smoke units to become

oversaturated allowing leakage onto the electronics. Note that operating your locomotive's

smoke unit without smoke fluid will cause damage to the heating element.

If you prefer to operate your locomotive without smoke, locate the smoke unit switches

under the rear sand dome or the middle sand dome and slide them to the OFF position. Refer to

Figure 2 on page 8 for the location of these switches.

Main smokestack

Front of locomotive

Figure 9. Smoke fluid locations

71-1155-250 ATSF 3000.indd 35

Rear of locomotive

Aux smoke fluid fill

Dome

Bell

Middle of locomotive

4/28/10 8:35 AM

Table of Contents

Vision pennsylvania cc2s 0-8-8-0