Instruction For Use; Cb Technique; Primary Air; Secondary Air - SCAN 66 series Assembly And Instruction Manual

CB-technique (Clean Burning)
The wood-burning stove is equipped with CB technology. In order to
ensure an optimal combustion of released gases under the incinera-
tion process, air will pass through a specially developed canal system.
The heated air is led into the combustion chamber through the small
holes at the rear of the burn chamber. This airflow is driven by the
combustion rate and thus cannot be regulated.

Primary air

The primary air regulation mechanism is used for lighting the fire, or
to boost the burning process when you put wood on. The primary air
vent can be 0 - 30% open if you use hard wood fuel such as oak and
beech. You can close the primary air vent if you use soft wood such
as birch or pine for fuel.
Settings for normal load: 0 - 30%

Secondary air

Secondary air is pre-heated and fed indirectly to the fire. At the same
time, the secondary airflow cleans the glass pane to avoid soot build-
up. If you over-restrict the secondary airflow, soot can build up on the
glass pane. The secondary airflow determines the heat output from
your wood stove.
Settings for normal load: 50 - 70%
I N S T R U C T I O N S F O R H E AT I N G

Ash drawer

Baffle plates

The baffle plates are located in the upper part of the combustion
chamber. The plates hold back smoke, making sure it stays inside
the combustion chamber for a longer time before escaping through
the chimney. This reduces the smoke gas temperature as the gases
have more time to dissipate heat to the wood-burning stove. The
baffle plates must be removed for sweeping; see „Maintaining your
wood-burning stove". Note that the baffle plates are made of porous,
ceramic material, and can break. Exercise care when working. The
baffle plates are subject to wear and tear, and are not covered by the
warranty.
Ash drawer
Open the glass door to access the ash pan which is located below the
combustion chamber.
Keep the ash pan closed at all times when the wood stove is lit.
The ash drawer must not be overfilled and must therefore be emp-
tied at regular intervals.

Log guard

The stove has a thick glass log guard that is easy to take out for clea-
ning (use normal glass cleaner).
Baffle plates
CB-technique
Secondary air
100%
0%
Primary air
Log guard
29