Table of Contents
Advertisement
20
CB-technique (Clean Burning)
The wood-burning stove is equipped with CB technology. In order to
ensure an optimal combustion of released gases under the incinera-
tion process, air will pass through a specially developed canal system.
The heated air is led into the combustion chamber through the small
holes at the rear of the burn chamber. This airflow is driven by the
combustion rate and thus cannot be regulated.
Primary air
The primary air regulation mechanism is used for lighting the fire, or
to boost the burning process when you put wood on. The primary air
vent can be 30 - 80% open if you use hard wood fuel such as oak and
beech. You can close the primary air vent if you use soft wood such
as birch or pine for fuel.
Settings for normal load: 30 - 50%
Secondary air
Secondary air is pre-heated and fed indirectly to the fire. At the same
time, the secondary airflow cleans the glass pane to avoid soot build-
up. If you over-restrict the secondary airflow, soot can build up on the
glass pane. The secondary airflow determines the heat output from
your wood stove.
Settings for normal load: 60 - 90%
Scan 85
NAVN:
EMNE:
MATERIALE:
DIMENSION:
I:\Udvikling\TEGNING\Scan85\90585012.idw
STI:
Handle for riddling grate
I N S T R U C T I O N F O R U S E
Brændkammer
N/A
VÆGT:
F
N/A
AREAL:
Ash container
Scan 85
NAVN:
MATERIALE:
DIMENSION:
Baffle plates
The baffle plates are located in the upper part of the combustion
chamber. The plates hold back smoke, making sure it stays inside
the combustion chamber for a longer time before escaping through
the chimney. This reduces the smoke gas temperature as the gases
have more time to dissipate heat to the wood-burning stove. The
baffle plates must be removed for sweeping; see „Maintaining your
wood-burning stove". Note that the baffle plates are made of porous,
ceramic material, and can break. Exercise care when working. The
baffle plates are subject to wear and tear, and are not covered by the
warranty.
Ash container
Open the door of the stove to reach the ash container under the
combustion chamber.
The ash container must always be closed while stoking.
The ash container must not be overfilled and must therefore be emp-
tied at regular intervals.
Handle for riddling grate
The stove is equipped with a riddling grate that empties ash from the
combustion chamber down into the ash container when activated.
The riddling grate must remain half open while stoking.
Baffle plates
CB Technology
Secondary air
90585012
TG.NR:
Primary air
08-09-10
DATO:
SIGN:
Krog Iversen & Co A/S
DK-5492 Vissenbjerg©
Brændkammer
EMNE:
VÆGT:
N/A
AREAL:
Scan 85
NAVN:
A
EMNE:
F
G
B
Adjustment of air supply,
primary and secondary damper
G
BC
0% - 100%
TG.NR:
90585012
N/A
08-09-10
DATO:
SIGN:
Krog Iversen & Co A/S
Primær + sekundær spjæld og rysterist.
DK-5492 Vissenbjerg©
BC
TG.NR:
90585013
Hide quick links:
Advertisement
Table of Contents
