ECO REFERENCE MANUAL
10.
ELECTRICAL INSTALLATION
SAFETY INFORMATION AND
GENERAL GUIDELINES
• Make sure that the motor terminals are
configured for the correct supply voltage
• Make sure that the input power supply is
isolated before making or changing any
connections
• The control power supply and motor leads
must be laid separately. They must not be
fed through the same cable conduit/trunking
and should cross at 90° wherever this is
unavoidable
/
/
/
&217$&725
)86(6
3(
7+5(( 3+$6(
• High voltage insulation test equipment must
not be used on any cables connected to the
inverter
(0& ),/7(5
0,&520$67(5 (FR
/
/
/
3(
3(
Motors can be connected to inverters
either individually or in parallel. For
parallel motor operation each motor
should have an overload protection
relay fitted. Set parameter P077 to 0
for multi-motor operation mode.
For wiring guidelines to minimise the
effect of electro-magnetic
interference (EMI), refer to the
relevant section of this manual.
02725
8
8
9
9
:
:
10-1