Main Function - ACME LED-MB500 User Manual

3. Function Display:
Used to show the various menus and the selected functions.
4. Fuse (T 3.15A):
Used to protect the fixture from damage of over current.
5. Power IN/OUT:
Used to connect the fixture to mains power.
6. DMX IN:
For DMX512 link, use 3-pin XLR plug cable to link the DMX controller and the fixture, and input
the DMX signal.
7. DMX OUT:
For DMX512 link, use 3-pin XLR plug cable to link the next fixture and output the DMX signal.
8. Only For Remote Control:
Used to connect with optional CA-8 to control the fixture for Stand by, Function and Mode
select.
9. Microphone:
Receives music signals for sound active.

3.2 Main Function

To select any functions, press the MENU button until the required function is showing on the
display. Select the function by pressing the ENTER button and the display will blink. Use the DOWN
and UP button to change the mode. Once the required mode has been selected, press the ENTER
button to setup to go back to the functions without any changes press the MENU button again.
Hold and press the MENU button for one second or wait for one minute to exit the menu mode.
The main functions are shown below:
5A