ACME LED-MB500 User Manual page 10

Tilt Inverse
To select he Tilt Inverse, press the ENTER button to show the TILT INVERSE on the display. Use the
DOWN and UP button to select the Yes (tilt inversion) or No (normal) mode. Once the mode has
been selected, press the ENTER button to setup, to go back to the functions without any change
press the MENU button again. Hold and press the MENU button about one second or wait for one
minute to exit the menu mode.
Back Light
To select the Back Light, press the ENTER button to show the BACK LIGHT on the display. Use the
DOWN and UP button to select the On (display on) or Off (display off) mode. Once the mode has
been selected, press the ENTER button to setup, to go back to the functions without any change
press the MENU button again. Hold and press the MENU button about one second or wait for one
minute to exit the menu mode.
Function Delay
To select the Function Delay, press the ENTER button to show the FUNCTION DELAY on the display.
Use the DOWN and UP button to select the No Delay or 1S Delay, 2S Delay, 3S Delay (wait for
1/2/3 seconds before these functions of 8/11CH are activated/deactivated). Once selected, press the
ENTER button to setup, to go back to the functions without any change press the MENU button
again. Hold and press the MENU button about one second or wait for one minute to exit the menu
mode.
Dimmer Calibrat.
To select the Dimmer Calibrat., press the ENTER button to show the DIMMER CALIBRAT. on the
display. Use the DOWN and UP button to adjust the dimmer from 50 to 100, press the ENTER
button to setup and store, to go back to the functions without any change press the MENU button
again. Hold and press the MENU button about one second or wait for one minute to exit the menu
mode.
Auto Test
To select the Auto Test, press the ENTER button to show the AUTO TEST on the display and the
9A