Kenmore w10680149B Installation Instruction page 11

Put power supply cord through the strain relief. Be sure that
the wire insulation on the power supply cord is inside the strain
relief. The strain relief should have a fight fit with the dryer
cabinet and be in a horizontal position. Do not further tighten
strain relief screws at this point.
if your outlet looks like this:
Power supply cord 4-wire receptacle
(NEMA Type 14-30R):
Go to "4-Wire Power Supply Cord
Connection".
Power supply cord 3-wire receptacle
(NEMA Type 10-30R):
Go to "3-Wire Power Supply Cord
Connection".
Remove center terminal block screw (B). Remove neutral ground
wire (E) from external ground conductor screw (A). Reinstall
ground conductor screw (A).
. onnect neutral ground wire
and neutral wire
E
4-wire Power Supply Cord Connection
IMPORTANT: A 4-wire connection is required for mobile homes and where
local codes do not permit the use of 3-wire connections.
4-wire receptacle (NEMA
type 14-30R)
4-prong plug
Spade terminals with
upturned ends
Ring terminals
Connect neutral ground wire (E) and neutral wire (white) (C)
of power supply cord under center terminal block screw (B).
Tighten screw.
3. Connect ground wire
e
Connect ground wire (F) (green or bare) of power supply cord
to external ground conductor screw (A). Tighten screw.
11