Kenmore w10680149B Installation Instruction page 12

4. Connect remaining wires
0
Connect remaining wires to outer terminal block screws.
Tighten screws. Finally° reinsert tab of terminal block cover into
slot of dryer rear panel. Secure cover with hold-down screw.
Now, go to "Venting Requirements."
2. Connect neutral wire
e
Connect neutral wire (white or center) (C) of power supply cord
to center terminal block screw (B). Tighten screw°
3-wire Power Supply Cord Connection
Use where local codes permit connecting cablnet-ground
conductor to neutral wire.
3-wire receptacle (NEMA
type 10-30R)
3-prong plug
Spade terminals with
upturned ends
Ring terminals
1. Remove center screw
B i
Remove center terminal block screw (B).
Connect remaining wires to outer terminal block screws. Tighten
screws. Finally, reinsert tab of terminal block cover into slot of
dryer rear panel. Secure cover with hold-down screw. Now, go
to "Venting Requirements."
12