Installation Through Side Of Masonry Chimney; Electrical Installation; Special Mobil Home Requirements - Breckwell LUXURY SERIES SP2700 Owner's Manual

E. INSTALLATION THROUGH SIDE OF MASONRY CHIMNEY
NOTE: Follow L-Vent chimney manufacturer's instructions.
1. Position the stove, adhering to the clearances in Figures 1 & 2. Mark
the center of the hole where the pipe is to pierce the masonry chim-
ney.
2. It will be necessary to break out the masonry around the location of
the pipe center mark. Use a 4-inch diameter hole for 3-inch pipe and
5-inch diameter hole for 4-inch pipe.
3. Measure and build chimney top plate. Cut out holes for chimney pipe,
and if used the outside air pipe.
4. Install the tee on the bottom of the vertical pipe system and lower it
down the chimney until the center branch of the tee is level with the
center of the hole in the masonry, as shown in Figure 10.
5. Install and seal the top plate from step 3 with non-hardening mastic.
Slip the storm collar over the pipe, and while holding the pipe at the
proper elevation, affi x the collar with a minimum of three ¼" stainless
steel sheet metal screws. Seal all joints and seams around the collar.
6. Connect the horizontal pipe by pushing it through the hole in the ma-
sonry and lining it up with the branch in the tee. Push the pipe into the
tee while twisting it to lock it into the tee.
7. If desired, once the horizontal pipe is in place, the space between the
pipe and masonry may be fi lled with high-temperature grout.
8. Install the trim collar. An adjustable pipe length and adapter may be
needed to fi nish the connection to the stove.

ELECTRICAL INSTALLATION

This stove is provided with a 6-foot grounded electrical cord extending
from the rear of the stove.
We recommend connecting to a good quality surge protector that
is plugged into a standard three-prong, 120V, 60 Hz electrical outlet.
Do NOT connect the unit to a GFCI socket.
Voltage variations can lead to serious performance problems. The Breck-
well electrical system is designed for 120V AC with no more than 5%
variation. Breckwell cannot accept responsibility for poor performance or
damage due to inadequate voltage. If connected to an older, two-prong
outlet, a separate ground wire should be run to a proper ground (refer this
to a qualifi ed technician). Always route the electrical cord so that it will not
come in contact with any hot part of the stove.

SPECIAL MOBIL HOME REQUIREMENTS

WARNING: DO NOT INSTALL IN A SLEEPING ROOM.
NOTE: Installation should be in accordance with the Manufactured
Home and Safety Standard (HUD), CFR 3280, Part 24
For installation in a mobile home, an outside source of combustion air
must be used (See "COMBUSTION AIR SUPPLY").
The SP2700 must be grounded to the steel chassis of the home with 8
Ga. copper wire using a serrated or star washer to penetrate paint or pro-
tective coating to ensure grounding.
The SP2700 must be securely fastened to the fl oor of the mobile home.
Refer to "VENTING" for proper exhaust confi gurations.
CAUTION: THE STRUCTURAL INTEGRITY OF THE MOBILE HOME
FLOOR, WALL AND CEILING/ROOF MUST BE MAINTAINED.
10
INSTALLATION INSTALLATION
FIGURE 9
FIGURE 10