Breckwell LUXURY SERIES SP2700 Owner's Manual page 17

CLEANING
a. Heat Exchange Tubes – Your Breckwell stove is
designed with a built-in heat exchange tube cleaner.
This should be used every two or three days to re-
move accumulated ash on the tubes, which reduces
the effi ciency of your unit. Insert the handle end (with
hole) of the cleaning tool onto the cleaning rod (refer
to fi gure 14). The cleaner rod is located in the grill
above the stove door. Move the cleaner rod back
and forth several times to clean the heat exchanger
tubes. When fi nished be sure to leave tube cleaner
at the rear of the stove.
b. Interior Chambers – Three ash doors in the fi rebox
in the SP2700 can be removed for periodic cleaning
(refer to fi gure 17). These doors allow access to the
chamber surrounding the fi rebox.
Periodically, you must vacuum ashes from this chamber.
In some cases you will need to remove creosote, which
can accumulate rapidly under certain conditions. A small
wire brush can be used. It is important to remove this
creosote because it is highly combustible. INSPECT
BEHIND THESE CLEANING PLATES AT LEAST ONCE
PER TON OF PELLETS BURNED UNTIL YOU ARE
FAMILIAR WITH HOW ASHES AND CREOSOTE AC-
CUMULATE WITH YOUR OPERATING PRACTICES.
Use the small wire brush to also clean the inside of the
chamber walls, above the access doors.
BLOWERS
DANGER: RISK OF ELECTRIC SHOCK. DISCONNECT
POWER BEFORE SERVICING UNIT.
Cleaning - Over a period of time, ashes or dust may
collect on the blades of both the combustion blower and
convection blower. Periodically the blowers should be
vacuumed clean as these ashes can impede perfor-
mance. Creosote can also accumulate in the combustion
blower. This needs to be brushed clean. The convection
blower is accessed by opening the stove's left side panel.
The combustion blower can be accessed by opening the
right side panel. The convection blower is on the left (fac-
ing stove), and the combustion blower is on the right.
NOTE: When cleaning, be careful not to dislodge balanc-
ing clip on convection blower or to bend fan blades.
Some stove owners lightly spray an anti-creosote chemi-
cal on the fi re to help reduce creosote formation within
the stove.
MAINTENANCE MAINTENANCE
FIGURE 17
FIGURE 18
FIGURE 19
17