Toyota 2014 Sienna Manual page 629

Hide thumbs Also See for 2014 Sienna:

Table of Contents

Programming a Rolling Code system (for U.S.A. owners)

If your device is Rolling Code equipped, follow the steps under the

heading "Programming the HomeLink

steps listed below.

Locate the training button on the ceiling mounted garage door

opener motor. The exact location and color of the button may

vary by brand of garage door opener.

Refer to the operation manual supplied with the garage door opener

for the location of the training button.

Press the training button.

Following this step, you have 30 seconds in which to initiate step 3

Press and hold the vehicle's programmed HomeLink

for 2 seconds and release it. Repeat this step once again. The

garage door may open.

If the garage door opens, the programming process is complete. If

the door does not open, press and release the button a third time.

This third press and release will complete the programming process

by opening the garage door.

The ceiling mounted garage door opener motor should now recog-

nize the HomeLink

Repeat the steps above to program another rolling code sys-

tem for any of the remaining HomeLink

SIENNA_OM_OM45483U_(U)

" before proceeding with the

transceiver and operate the garage door.

3-8. Other interior features

Show Quick Links

Table of Contents