Toyota 2014 Sienna Manual page 44

1-2. Opening, closing and locking the doors
■
Switching the door unlock function
It is possible to set which doors the entry function unlocks using the wireless
remote control.
STEP 1
Turn the "ENGINE START STOP" switch off.
STEP 2
When the indicator on the key surface is not on, press and hold
and holding
The setting changes each time an operation is performed, as shown below.
(When changing the setting continuously, release the buttons, wait for at least
5 seconds, and repeat
Multi-information
display
For vehicles equipped with an alarm, to prevent unintended triggering of the
alarm, unlock the doors using the wireless remote control and open and
close a door once after the settings have been changed. (If a door is not
opened within 60 seconds after
again and the alarm will automatically be set.)
In case that the alarm is triggered, immediately stop the alarm. (P. 163)
44
SIENNA_OM_OM45483U_(U)
, , , or
.
STEP 2
.)
Unlocking function
Holding the driver's door
handle unlocks only the
driver's door and driver
side power sliding door.
Holding the front passen-
ger's door handle or pull-
ing either power sliding
door handle unlocks all
doors.
Holding either front door
handle or pulling either
power sliding door handle
unlocks all doors.
for about 5 seconds while pressing
Beep
Exterior: Beeps three
times
Interior: Pings once
Exterior: Beeps twice
Interior: Pings once
is pressed, the doors will be locked