RGBlink VSP 516S User Manual page 138

3. Locate the Gigabit network board port 3, 4, 5 into the main board, tighten
the screws, as shown in Figure 4.
4. Close and reinstall the processor, see ―Closing the Processor‖ in Part 3.
Part 3: Closing the Processor
Specific steps are as follows:
1. Secure the back panel with the screws.
2. Replace the top cover on the VSP 516S.
3. Fasten it with the screw that were removed in ―Opening the Processor‖
part.
4. If desired, reconnect all cables.
VSP 516S
(Figure 4)
User Manual 138