Table of Contents
Advertisement
5. Lift the top cover and back panel.
Caution: Do not touch any electronic components inside the VSP 516S.
Doing so could damage the processor. Electrostatic discharge (ESD) can
damage IC chips even though you cannot feel it. You must be electrically
grounded before proceeding with maintenance. A grounding wrist strap is
recommended.
6. Perform the desired maintenance procedure. See ―Installing an Optional
SDI Input Board‖ in Part 2.
Part 2: Installing an Optional SDI Input Board
Install an optional SDI input board in the VSP 516S as follows:
Warning: Changes to electronic components must be performed by
authorized service personnel only.
1. Open the processor. See ―Opening the Switcher‖ in Part 1.
2. On the main board port 2, locate SDI input board port 1, align and gently
apply pressure to mate input board with main board, as shown in Figure 3.
VSP 516S
(Figure 2)
User Manual
136
Advertisement
Table of Contents
