Mounting The Frame - Gamma 7000 Es Owner's Manual

MOUNTING THE FRAME

Adjusting the Frame Support Posts
Place the racquet frame over the center
support slide and onto the frame support.
Loosen the lever lock bolt on one support
post. Slide the post outward until the center
support of the racquet support slide is posi-
tioned near the inside surface of the racquet
frame. Securely tighten the lever lock bolt.
Adjust the opposite post using the same
procedure.
Caution: To avoid racquet damage, the sup-
port slide should not contact the racquet prior
to fixing the support posts.
Shoulder Support Adjustment
The shoulder supports on the 7000Es are
adjustable to provide support to the racquet
frame. Loosen the knurled knob at the bottom
of the shoulder support and swivel the sup-
port so that the pads will contact the frame
squarely when the arms are closed against
the racquet. Should the shoulder supports
block string holes, adjust the position of the
racquet between the arms until the shoulder
supports contact the racquet between grom-
met holes.
Securing the Shoulder Supports
Secure the racquet frame with the shoulder
supports by rotating the large adjustment
knobs on the outside of the support post
assemblies clockwise. Adjust the supports
until firm contact is made between the shoul-
der supports and the frame.
The tear drop shaped holes torwards the
back of the shoulder supports are handy
for holding the loose end of the string
while pulling the string through the
racquet. Simply insert the loose end into
the tear drop shaped holes and slide the
string into the point of the hole.
8