Gamma 7000 Es Owner's Manual page 8

tional separation space between the mounting arms. The outer holes should be used whenever
possible provide maximum support for securing the support post to the turntable.
alcohol. After this type of thorough cleaning, the post and tube should be treated with a light
coating of machine oil to protect the surfaces against corrosion and to ensure smooth operation.
ASSEMBLY INSTRUCTIONS
Installing the Racquet Mounting System
Align the threaded hole in the bottom of the
frame support post with the slot in the turn-
table. Screw the lever lock bolt with washer
into the outermost hole located in the bottom
of the support post and tighten gently.Position
the washer with the rounded edge toward the
turntable.
Repeat procedure for the support post on the
opposite side of the turntable.
There are two holes located in the bottom of
the support post. The inner hole is for use
with super oversize racquets to provide addi-
Installing the Fixed Clamps
To install the clamps, remove the winged
lock knob to separate the knob from the lower
guide bushing. Be careful not to lose the
radial thrust bearing components located in
the center recess of the knob.
Align the clamp base with the clamp slot of
the turntable base. Insert the clamp guide
bushing into the clamp from the bottom of the
turntable making sure to engage the guide
with the clamp slot.
Fixed Clamp Installation
Place the load bushing into the top of the
clamp base mating it to the lower guide
bushing. After checking that the thrust bear-
ing is positioned correctly in the base of the
winged lock knob, screw the knob into the
base bushing until fully seated.
The post of the string clamp head and tube of
the string clamp base are treated with grease
to provide protection against corrosion dur-
ing shipping. Remove any excessive grease
with a clean cloth prior to use. The post and
tube may also be cleaned with isopropyl
6