Change Base Station System Identifier; Enabling Over The Air (Ota) Registration; Increasing Or Decreasing The Number Of Beltpacks Per Base Station - ClearCom FreeSpeak II User Manual

2) Edit the required system fields.

10.9.2 Change Base station System identifier

Start the Config Editor and ensure the map file is loaded. (Config
Editor/System/Map File/Load).
1) Select the System tab.
2) Click Unlock SYS ID.
3) Enter the Clear-Com config password and click OK. (Password = Clear-
Com).
4) Change the system identifier number to an unused number.
5) To re-lock the system click Unlock SYS ID. Enter the re-lock system
password and click OK. (Re-lock system password = Clear-ComOff).
6) Exit the Config Editor and re-start it to complete the locking of the
system.

10.9.3 Enabling Over The Air (OTA) registration

To enable OTA, see 10.3 Registering beltpacks using the over the air (OTA)
facility.
10.9.4 Increasing or decreasing the number of beltpacks per
Base station
You can enter custom codes to increase or decrease the number of beltpacks to
20 or 5. To do so:
1) Enter the Diagnostics tool. See 10.10 Diagnostics.
2) From the Diagnostics tool, select Event Log.
3) Form the upper right corner of the Diagnostics screen, select Request
Info.
Page 152
User Guide | FreeSpeak II™ Base station version
Figure 10-20 System Tab