Loading A Configuration File From A Base Station Using A Serial Link - ClearCom FreeSpeak II User Manual

10.1.2 Loading a configuration file from a Base station using a
serial link
1) Connect the PC to the Base station using a standard FreeSpeak II serial
cable.
2) From the Serial comms list, select a COM port. Power on the FS II Base
station and wait for at least 30 seconds.
Note: The Serial comms list shows only those ports that are available
3) In the Serial Comms section of the screen, click Retrieve. If the program
fails to connect to the Base station, the following dialog appears:
If this occurs, check the cable, PC and Base station connection, and also
make sure that 30 seconds have elapsed since powering on the Base
station to ensure that serial comms have been activated.
The following screen is an example of a loaded configuration (with
beltpacks selected):
Page 126
for connection to the Base station. If the required port is not
shown, it may be that another program is using this port. Close
the other program, and try again.
Figure 10-2 Configuration Editor Serial Timeout
User Guide | FreeSpeak II™ Base station version