Analog Output - SMC Networks ZSE30 Series Manual

High-Precision Digital Pressure Switch

Analog Output

Voltage output
5
1
0.6
A B C
Descriptions
Unit display
Displays present unit (only for units of kPa and
MPa).
Output (OUT1) display (Green)
Lights up when switch output (OUT1) is turned ON.
button (UP)
Use this button to select the mode or increase the
ON/OFF set-value.
It is also used for switching to the peak display
mode.
S button (SET)
Use this button to change the mode or confirm the
set-value.
Functions
(Refer to pages 10 and 11 for details.)
Copy function
Auto-preset function
Precision indicator setting function
Peak display function
Bottom display function
Key lock function (Security code
input can be selected.)
Zero-out function
Anti-chattering function
Unit display switching function
Power-saving mode
Display resolution-switch function
kPa⇔MPa switch function
2-Color Display
Current output
20
4
2.4
A B
Pressure
Copies the settings of the master sensor to the slave sensors.
Calculates and enters rough set values automatically from the actual operating conditions.
Can retain the maximum pressure value displayed during measurement.
Can retain the minimum pressure value displayed during measurement.
The key board can be locked to prevent any incorrect function of the operation switch.
The pressure display can be set at zero when the pressure is open to the atmosphere.
Prevents possible malfunction due to sudden fluctuations in the primary pressure by adjusting the response time.
Converts display resolution from the normal value of 1/1000 to 1/100.
ZSE30A
Series
Range Rated pressure range
For vacuum
0.0 to –101.0 kPa
pressure
For compound
–100.0 to 100.0 kPa
pressure
For positive
–0.100 to 1.000 MPa –0.1 MPa
pressure
C
Pressure
LCD
Displays the current pressure, set mode, and error
code. Always use red or green display; or switch
between green and red according to the output.
Four different display settings are available.
Output (OUT2) display (Red)
Lights up when switch output (OUT2) is turned ON.
button (DOWN)
Use this button to select the mode or decrease the
ON/OFF set-value.
It is also used for switching to the bottom display
mode.
Evens out deviations in the displayed value.
Can convert the display value.
Reduces power consumption.
It reduces the monitor to flicker.
Converts the unit between kPa and MPa.
( )
F /ISE30A
A B C
— 0 –101 kPa
— –100 kPa 100 kPa
0 1 MPa
3