SMC Networks ZSE30 Series Manual page 6

ZSE30/ISE30
Series
Setting
Press the
Measuring
mode
Press the
and hold for 2 sec. or longer.
Initial Setting
Initial setting mode
Press and hold the SET button for 2 seconds or longer.
Display monitor will be per Figure A below, and the switch
will now be in the display color setting mode.
PRESSURE
OUT
Figure A
If the unit specification indicated at the time of ordering is "M",
the fixed SI unit will be used. If it is Nil, refer to "Unit Switching
Function" on page 16-2-8.
1. Display color setting
Select the color for LCD display.
Press the UP or DOWN button to choose a display color.
PRESSURE
OUT
ON: Red
PRESSURE
OUT
ON/OFF: Red
Press the SET button to set the color and proceed to the
operating mode setting.
If the analog output is set, press the
and select the desired display color from
(Red). Press the SET button to exit this mode and return to
the measuring mode.
2. Operating mode setting
This mode will let you select the switch operating mode.
While the current operating mode is displayed, press the
UP or DOWN button to select a newly desired operating
PRESSURE
OUT
Hysteresis mode
Hysteresis Hysteresis
(H) (H)
ON ON
OFF OFF
P1 n1
(Standard: Factory setting) (Reversed)
Press the SET button to set the mode and proceed to the
output type setting.
16-2-6
Pressure setting
button.
SET
Enter the set value of the
pressure to perform switch
output.
Initial setting
Set the output type, response
button
SET
time, and display color
switching.
PRESSURE
OUT
ON: Green
PRESSURE
OUT
ON/OFF: Green
UP or DOWN button
(Green) or
PRESSURE
OUT
Window comparator mode
Hysteresis Hysteresis Hysteresis
(H)
(H) (H)
ON ON
OFF OFF
P1 P2 n1
(Standard: Factory setting) (Reversed)
Press the SET button.
Press the SET button.
3. Output type setting
The type of switch output can be set arbitrarily.
While the current output type is displayed, press the
DOWN button to switch between normally open
normally closed
PRESSURE
OUT
Normally open
Press the SET button to set the output type and proceed to
the response time setting.
4. Response time setting
The switch output response time can be set arbitrarily.
Chattering can be prevented with a response time setting.
While the current response time is displayed, press the
or DOWN button to select a new response time.
PRESSURE
OUT
2.5 ms
Press the SET button to set the response time and proceed
to the auto preset setting.
If the operating mode is the window comparator mode, press
the SET button to return to the measuring mode.
5. Auto preset setting
This function stores the measuring pressure that is set
during the auto preset mode as a basic value.
While the current setting is displayed, press the
DOWN button to select it as an auto preset setting.
PRESSURE
OUT
Hysteresis
(H)
Manual
Press the SET button to set the auto preset and return to the
measuring mode.
n2
Measuring mode
Detects and displays the pressure and
performs switch operations. Other functions
such as the value clear function can be set
according to the application purpose.
.
PRESSURE
OUT
Normally closed
PRESSURE
OUT OUT
20 ms
PRESSURE
OUT OUT
640 ms
PRESSURE
OUT
Auto
and
UP
PRESSURE
160 ms
PRESSURE
1280 ms
UP or