Konica Minolta CM-2600d Instruction Manual page 96

Connecting to an External Device
Printer Cable Wiring Diagram
• For D-sub, 9pin
Instrument
1
Pin No. Signal
3 TXD
5 GND
8 CTS
• For D-sub, 25pin
Instrument
1
Pin No. Signal
3 TXD
5 GND
8 CTS
Auto Print
If Auto Print has been setup beforehand, the measurement data can be printed as each measurement is
made.
N
ote
The instrument and printer must be connected using a printer cable that is wired as shown in "Printer Cable Wir-
ing Diagram" (page E-92).
[Procedure]
Make sure that power to the instrument is turned OFF.
1. Connect the instrument to the printer with a printer cable.
E-94
8
8
Printer
(For D-sub, 9-pin)
5 4 3 2 1
9 8 7 6
Signal Pin No.
DATA 3
GND 5
BUSY 8
Printer
(For D-sub, 25-pin)
Signal Pin No.
DATA 2
BUSY 5
GND 7