Konica Minolta CM-2600d Instruction Manual page 107

<Quitting Measurement>
Turn B to select "END", then press A.
Measurement will be quit.
M
emo
If you made a setting to save the average at step 8, the average of all measurement in a series will be calcu-
lated and displayed at the end of the task's last "JOB
stored in the instrument's memory. The measurement result for each "JOB
If you did not make a setting to save the average at step 8, the measurement result for individual measurement
("JOB ") will be stored in the instrument's memory.
*
N
ote
• In TASK mode, only the data taken by the previous measurement will be displayed. By using the instru-
ment alone, it is not possible to view the data taken by the measurement performed before.
• The measurement results will be saved only after a series of measurements set as a task is completed. If TASK
measurement is cancelled on the way, all data in the series will not be saved.
* ". In this case, only the calculated average will be
* " will not be saved.
TASK Mode
E-105