Konica Minolta CM-2600d Instruction Manual page 57

7
Turn B to select the value for an item to be set, then press A.
The selected value will be set,
and the cursor will move to the
next value.
M
emo
A
Keeping
cause the cursor to move from one
value to another continuously. The
cursor will stop when it reaches
"ADJUST".
<Settings>
• + ("+" tolerance range) : "----" (No setting), 0.1 to 20.0
• - : ("-" tolerance range) : "----" (No setting), 0.1 to 20.0
• Keeping B held down to left or right will cause the value to change continuously.
• To change a value that has been set, press C (MEAS. button) in the screen where "↑ : <MEAS.>"
is displayed. This will take you to the previous items, so change the value.
• Pressing the MEAS. button after the cursor has returned to the first item (∆L*) will exit from the set-
ting screen and the cursor will locate on "ADJUST".
8
If illuminant 2 has been selected, the observer and illuminant conditions for illumi-
nant 2 set in the measurement condition (COND1 to COND6) will be displayed.
Turn B to select it and press A to switch to the screen that allows setting
of box tolerances for illuminant 2. Set the desired box tolerances in the same way
as in steps 6 and 7.
9
Turn B to select "PREV", and then press A.
The <TARGET> screen will reap-
pear.
held down will
• Example when illuminant 2 is not selected.
• Example when illuminant 2 is selected.
Setting Color Difference Tolerances
E-55