Konica Minolta CM-2600d Instruction Manual page 106

TASK Mode
10
Place the specimen measuring port to the specimen according to the message dis-
played, make sure that
M
emo
If does not appear due to the auto power save function, this may be due the fact that it can take time
to start measurement after C is pressed.
11
<Performing the Next Measurement>
Turn B to select "NEXT" then press A.
The message for "JOB
for the previous measurement will
appear.
<Performing the Same Measurement Again>
Turn B to select "REDO", then press A.
The message "JOB
played just before the measurement
was performed will appear.
E-104
is displayed, then press C (MEAS. button).
" displayed
*
* " that was dis-