Konica Minolta CM-2600d Instruction Manual page 81

2
Place the specimen measuring port to the specimen to be measured, and then
press C (MEAS. button).
If 2 is set for "MANUAL AVG.
TIMES" or if 3 or a higher value is
set and the standard deviation is not
below the specified one, place the
specimen measuring port to the next
place and then press
button).
When the specified number of meas-
urements has been completed or the
standard deviation drops below the
specified one, the averaging result
will be displayed on the LCD.
M
emo
• To exit manual averaging and display the results before the specified number of measurements is completed or
before the specified standard deviation is reached, press A.
• If does not appear due to the auto power save function, this may be due the fact that it can take time
to start measurement after C is pressed.
C
(MEAS.
• The number of completed measurements including the one cur-
rently in progress and standard deviation will be displayed during
measurement.
Measuring the Average
E-79